Table of Contents
Advertisement
Basic format for control data
The transmission of control data from the computer
starts with a STX signal, followed by the command, the
parameters, and lastly an ETX signal in that order. If
there are no parameters, then the parameter signal does
not need to be sent.
STX
C1 C2 C3
Start
Colon
(02h)
3-character command
(3 bytes)
Command
Command
Parameter
PON
None
POF
None
AVL
AMT
IMS
None
HM1
HM2
DL1
DV1
PC1
VD1
YP1
UD1
None
ZOOM
DAM
FULL
NORM
ZOM2
LID:MOD
:
P1 P2 P3 P4
P5
ETX
End
(03h)
Parameter(s)
Control details
Power ON
Power OFF
***
Volume 000 - 100
0
Audio MUTE OFF
1
Audio MUTE ON
Input select (toggle)
HDMI 1 input
(HDMI1)
HDMI 2 input
(HDMI2)
DIGITAL LINK input
(DIGITAL LINK)
DVI-D IN input
(DVI-D)
PC IN input (PC)
VIDEO input
(VIDEO)
COMPONENT input
(COMPONENT/
RGB IN)
USB input (USB)
Screen mode select
(toggle)
Zoom1
16:9
4:3
Zoom2
0
[LightID]: [Off]
[LightID]: [External
1
control]
2
[LightID]: [Internal ID]
Note
●
If multiple commands are transmitted, be sure to
wait for the response for the first command to come
from this unit before sending the next command.
When sending a command which does not require
parameter, a colon (:) is not needed.
●
If an incorrect command is sent by mistake, this
unit will send an "ER401" command back to the
computer.
●
In Standby condition (power OFF with remote
control), the unit responds to PON command only.
●
Consult your local Panasonic dealer for detail
instructions on command usage.
For more details, visit the following web site.
http://panasonic.net/prodisplays/
23
English
Advertisement
Table of Contents
