Panasonic KX-TGF380AZ Operating Instructions Manual page 70

Useful Information
Problem
I cannot connect a mobile phone
to the base unit.
I cannot hear a dial tone.
The base unit beeps.
The unit does not work during a
power failure.
Menu list
Problem
I cannot register a handset to a
base unit.
Battery recharge
Problem
The handset beeps and/or
flashes.
70
Cause/solution
R Confirm that your mobile phone is turned on.
R Confirm that your mobile phone is within base unit range
(page 13).
R Your mobile phone's Bluetooth feature is turned off. Turn it on.
R Depending on the state of the wireless environment, such as
the presence of any electrical interference, there may be a
delay even if the auto connection feature is turned on. You can
connect to the base unit manually (page 18).
R The mobile phone has not been paired to the base unit. Pair the
mobile phone (page 16).
R If your mobile phone is already connected to another Bluetooth
device such as a Bluetooth headset or other Panasonic DECT
phone, disconnect the device, then perform the connecting
procedure to the base unit.
R If your mobile phone is already registered on another Panasonic
DECT phone, this function will not work properly. We strongly
recommend that you remove the registration of this phone on
both your mobile phone and on the other Panasonic DECT
phone.
R Make sure that the MOBILE indicator lights up (page 14).
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working telephone
operates properly, contact our service personnel to have the
unit repaired. If the working telephone does not operate
properly, contact your phone service provider.
R New messages have been recorded. Listen to the new
messages (page 59).
R You can insert 2 AAA (R03) batteries (not supplied) into the
base unit that will power the unit temporarily in the event of a
power failure (page 10).
R The base unit display is blank if the saving mode is "On"
(page 11).
Cause/solution
R The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 48).
Cause/solution
R Battery charge is low. Fully charge the batteries (page 10).