Panasonic KX-TGF380AZ Operating Instructions Manual page 56

Using Bluetooth® Devices
R Only 2 Bluetooth devices can be used with the
unit at the same time (for example, 2 mobile
lines, or the headset and 1 mobile line).
R For best performance, we recommend using a
Bluetooth headset within 1 m of the base unit. A
headset can communicate with the base unit
within a range of approximately 10 m.
Pairing a headset to the base unit
Important:
R Make sure that the Bluetooth headset is not
connected to any other Bluetooth device.
Handset / Base unit
1
Your headset:
Set your headset to pairing mode.
R Refer to the headset operating instructions.
2
MMENUN#621
3
If your headset PIN is "0000", go to step 4.
If your headset PIN is other than "0000",
press MCLEARN, then enter your headset PIN.
R Typically, default PIN is "0000". Refer to
the headset operating instructions.
4
Press MOKN, then wait until a long beep
sounds.
5
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
R When is displayed on the base unit, the
headset is available for use.
Connecting/disconnecting a headset
If you cannot connect the headset and base unit
using the headset, you can connect using the unit.
To use your headset with another Bluetooth
device such as a mobile phone, you may need to
disconnect it from the base unit.
You can configure this setting using either the
base unit or one of the handsets.
Important:
R Make sure that the headset is turned on.
Handset / Base unit
1
To connect/disconnect:
MMENUN#622
R A long beep sounds.
2
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
56
Unpairing a headset
You can cancel a pairing of the headset that is
stored to the base unit.
Handset / Base unit
1
MMENUN#612
2
MbN: "Yes" a MSELECTN
R When the headset is unpaired, the
disappears from the base unit display.
3
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Operating a Bluetooth wireless
headset using a landline
Important:
R Refer to your headset operating instructions for
headset operations.
Answering landline calls with your headset
To answer a landline call, press your headset's
button referring to your headset operating
instructions.
When you finish talking, press your headset's
button referring to your headset operating
instructions.
Note:
R If you cannot hang up the call using your
headset, press MZN on the base unit 2 times.
Switching between the base unit and your
headset
You can switch between the base unit and your
headset:
– during a landline call with the base unit.
– during an intercom call between the base unit
and handset.
– while listening to messages recorded on the
base unit answering system.
n To switch to your headset:
Press M N on the base unit.
n To switch to the base unit:
Lift the corded handset to talk with the corded
handset.
or
Press MZN to talk with the speakerphone.