Baby Monitor - Panasonic KX-TGF380AZ Operating Instructions Manual

override night mode and ring the unit (Caller ID
subscribers only).
Important:
R Make sure the unit's date and time setting is
correct (page 15).
R If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
Handset
1
MMENUN#238
2
MbN: Select the desired setting. a MSAVEN
R If you select "Off", press MOFFN to exit.
3
Enter the desired hour and minute you wish to
start this feature.
4
*: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you wish to
end this feature.
6
*: Select "AM" or "PM".
7
MSAVEN a MOFFN
Base unit
1
MMENUN#238
2
MbN: Select the desired setting. a MSAVEN
R If you select "Off", press MEXITN to exit.
3
Enter the desired hour and minute you wish to
start this feature.
4
MAM/PMN: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you wish to
end this feature.
6
MAM/PMN: Select "AM" or "PM".
7
MSAVEN a MEXITN
Changing the start and end time
Handset / Base unit
1
MMENUN#237
2
Continue from step 3 for handset or step 3 for
base unit, "Turning night mode on/off",
page 45.
Selecting groups to bypass night mode
Handset / Base unit
1
MMENUN#241
2
MbN: Select the desired group. a MSELECTN
R " " is displayed next to the selected group
numbers.
R To cancel the selected group:
MbN: Select the group. a Press MSELECTN
again. " " disappears.
3
MSAVEN
4
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN

Baby monitor

This feature allows you to listen in on a room
where another handset is located, allowing you to
easily monitor from different areas of the house or
place. The monitored handset (placed in a baby's
room, for example) will automatically call the
monitoring handset, base unit, or the phone
number stored when it detects sound.
Important:
R You should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For example,
test its sensitivity. Check the connection if you
are diverting the baby monitor to an outside line.
R This feature should not be used as a substitute
for a medical or caregiver's supervision. It is the
caregiver's responsibility to stay close enough
to handle any eventuality.
Note:
R If the unit is connected to a PBX system, you
cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset on
charger.
R The monitored handset never rings while it is
being monitored. If the base unit is placed near
the monitored handset, we recommend turning
off the base unit ringer volume (page 39, 41)
Setting the baby monitor
Perform the setting operation with the handset to
be monitored (for example, the handset placed in
a baby's room).
To monitor with a unit
The internal baby monitor feature is available:
– between handsets
– between a handset and the base unit
Programming
45