ray VISION User Manual page 39

RAY User Guide
2 RAY is now in
with your fingers.
You can now say the digits or the entire number. After a one second of
silence, RAY will translate the speech impression into a textual string of
numbers and will read it aloud.
3 To call for an action, while you are in a numeric keypad mode (and there is no
recognition of words and letters), you can simply say "RAY" to dial the call.
Note, when you are in a text entry mode, you can speak a complete sentence and
get it registered in the input buffer.
Note
While in speech recognition mode, you can activate the underlying functions
available in the system by saying the following commands:
To enter action mode while speaking a sentence use one of the following
words: RAY, Action, Actions, Done typing, Finish typing, End typing.
You don't need to enter action mode if you are in the dialer screen which
recognize only numbers.
• Back, Previous screen: Returns to the previous screen and leaves the
Dialer. This is under the digit 4.
• Read: Reads out the entire number that you entered. This is under the
digit 2.
• Dial, Finish, Finish typing, Send: Dials the number or send the
sentence that you entered. This is under the digit 6.
• Delete Number, Delete Word: Clears the entire number that you
entered. This is under the digit 7.
• Delete: Erases the last digit of the number or the last letter in a word
that you entered. This is under the digit 8.
For example, say "RAY Delete Number" to clear the entire number that
you entered.
Note
If you opened the Dialer and then accidently ended speech recognition mode
by touching the keypad, you can reactivate speech recognition mode by
moving your finger to the number 0 and holding it there for a moment.
speech recognition listening mode until you touch the screen
39
RAY Interface Basics