ray VISION User Manual page 26

RAY User Guide
To select options To select To select To select
►
1 Touch anywhere on its screen with your finger. A special tone is sounded for
each screen open on the device. RAY also has a distinct vibration for each
screen.
If you are touching too far away from the center of the screen, then a special
cancellation tone is sounded and your touch is ignored. In this case, simply lift
your finger, and place it near the middle of the screen.
2 Slide your finger a little in a specific direction until you hear Ray say the name
of the option that you want to select. Then, stop without lifting your finger off
the screen.
You should move your finger far enough to hear the name of the desired
option, but not too far as to exit the screen.
3 To select the option that RAY reads out, simply lift your finger off the screen.
RAY then tells you the next step.
Tip
If you do not want to select the option that you hear, then just keep sliding
your finger until it is off the screen. When the device detects that your finger
moved off the screen, it sounds a special cancellation tone to indicate that
your touch on the screen will be ignored.
Tip
After you place and hold your finger anywhere on the screen for three
seconds, RAY enters special help mode.
It will first read the basic information about the screen you are on.
You than must lift up your finger and touch it again to choose one of the
three options available upon sliding your finger to the right – get basic
system information including battery status and such; getting extended help
information and using guidance; and getting back to the last screen.
options on RAY's touch screen options options on RAY's touch screen: : : : on RAY's touch screen on RAY's touch screen
26
RAY Interface Basics