Operating The Timer; Set And Forget Operation - Rinnai rhfe-431ft Instruction Manual

Before operating the Timarls), the closk time muat be cone& and a starting time and finishing
time for the Timer@) must be programmd. See pages 13 and 14. The two Timers operate in
the same way. This heater does not commence operation at the programmed starting time.
It will attempt to heat a room by the programmed starting time. See Pm-heat page 16, for further
0
1
\
To select the Timer(s) to commence heating:
y?mq
Check the time shown on the Digital Display is
correct. See page 13. Check the ON and OFF
times, for both Timers if necessary, see page 14.
Press the ON-OFF button to operate the heater. The
On indicator will glow green and the heater will
begin to operate. Select the desired temperature
setting.
Press the Timer 1 and/or Timer 2 button(s).
The Timer indicator(s) will glow and the heater
will remain on standby until one hour prior to the
time programmed into the selected Timer(s) is
reached. When this time is reached, the Timer
indicator will flash and the heater will operate.
The ON indicator glows red when the heater
commences operation.
SET AND FORGET OPERATION
Your heater can be operated to alternate between Timers automatically during cold weather by
selecting Timer 1 and Timer 2 together. Both Timer indicators will glow. The appliance will
remain on standby at intervals between the programmed finishing and starting times of each
Timer. While the heater is operating during programmed intervals the Timer indicator will flash.
If there is a power failure, the system memory will retain the Timer programs, and the clock
will stop at the time the power goes off. The clock will start again when the power comes
back on, but the time will be slow by the duration of the power failure. To set the clock to
the correct time after the power has come back on, simply follow the instructions on