About Your Projector; Remote Control - Panasonic PT-AX200E Operating Instructions Manual

About Your Projector

Remote control

POWER button
While the MAIN POWER
button is on, switch
between stand-by mode
and projection mode. (page 19)
PICTURE MODE buttons
Switch to the best setting
for a darker room.
Switch to the best setting
for a brighter room.
Display the FAVOURITE
LOAD menu. (page 22)
Switch to cycle through
the aspect ratio.
(page 23)
Display the main menu or
return to the previous
menu. (page 27)
Navigate through the
menus with FGIH, and
activate the menu item
with ENTER. (page 27)
Reset some of the
settings to the factory
default settings.
(page 23)
Switch to cycle through
the input method.
(page 26)
NOTE:
• Do not drop the remote control.
• Avoid contact with liquids or moisture.
• Use manganese batteries or alkaline batteries with the remote control.
• Do not attempt to modify or disassemble the remote control. Contact an Authorised Service Centre for repairs.
• Do not keep pressing the remote control buttons as this may shorten battery life.
• See "Remote control operation" on page 22.
Remote control signal emitter
Remote control signal. (page 22)
Turn the button backlight
of the remote control on/
off. (page 22)
Display the COLOUR
MANAGEMENT menu.
(page 24)
Display the PICTURE
menu. (page 23)
Return to the previous
menu. (page 27)
Capture the projected
image as a still picture.
(page 23)
Assign the frequently
used functions from the
option for shortcut.
(page 26)
Battery compartment
1. Press the tab and lift up the cover.
2. Insert the batteries according to the
polarity diagram indicated inside.
E
NGLISH - 11