Sleep; Altitude; Lamp Power; Lamp Runtime - Panasonic PT-AX200E Operating Instructions Manual

SLEEP

You can select the required duration of time and set the
off timer to turn off the power of the projector
automatically. 3 minutes before turn-off, the countdown
of minutes will be displayed in the lower right corner.
Press I H to cycle through the options.
OFF
60MIN.
90MIN.
120MIN.

ALTITUDE

If you use the projector at high elevation, the ALTITUDE
setting need to be HIGH to set the fan speed high. Press
I H to select the required option.
LOW The fan speed is low.
HIGH The fan speed is high.
NOTE:
• At 1 400 m (4 593 ft) above sea level, the setting must
be HIGH.
• The loudness of fan noise depends on the ALTITUDE
setting.

LAMP POWER

You can adjust the power of the lamp to save electricity,
prolong the lamp life and reduce the noise.
Options
When higher luminance is
NORMAL
required.
When lower luminance is
ECO-MODE
sufficient.
NOTE:
• When no input signal is detected, the function is
disabled.

LAMP RUNTIME

You can check how long time the lamp has been used.
NOTE:
240MIN.

TEST PATTERN

210MIN.
You can use the 2 different test patterns to adjust the
focus of the image.
180MIN.
150MIN.
Function
NOTE:
• LAMP RUNTIME is a relevant matter for lamp
replacement timing. See "Replacing the lamp unit" on
page 42.
1. Press the ENTER button to display the test
pattern 1 and adjust the focus with the focus ring.
2. Press the ENTER button to display the test
pattern 2 and adjust the focus with the focus ring
again.
3. Press the MENU or RETURN to return to the
previous menu, or press repeatedly to return to the
screen.
• When the projector and/or the screen is tilted, adjust
the focus at the centre of the image. The upper and
lower edge might be out of focus.
• When the image is distorted in keystone, adjust the
KEYSTONE in the POSITION menu.
OPTION menu
E
NGLISH - 39