Temp And Lamp Indicators; Managing The Indicated Problems - Panasonic PT-AX200E Operating Instructions Manual

TEMP and LAMP Indicators

Managing the indicated problems

If a problem should occur with the projector, the LAMP and/or TEMP
indicators will inform you. Manage the indicated problems as follow.
1. Confirm the status of all indicators and projector, and switch off
the projector in proper way.
2. Find out the cause of the problem by status of the LAMP and/or
TEMP indicators.
3. Follow the following instruction for each indication and solve the
problem.
4. Turn on the projector in the correct way and confirm the
indicator is not indicating a problem any longer.
NOTE:
• If no problem is found or the problem remains, do not turn on the projector. Instead contact an Authorised Service Centre.
LAMP indicator
Illuminating red
Indicator
LAMP RUNTIME has
Problem
reached 1 800 hours.
The lamp unit will run
Cause out soon and needs to
be replaced.
See "Replacing the
Remedy
lamp unit" on page 42.
TEMP indicator
Illuminating red and still projecting
Indicator
Flashing red and the POWER button is turned off
Problem The temperature inside and/or outside the projector is abnormally high.
The ventilation openings are
Cause
covered.
Remove the object(s) from the
Remedy ventilation openings or clear
around the projector.
E
40 - NGLISH
Flashing red
The lamp circuit failure, abnormal function or lamp unit is damaged.
The MAIN POWER is
switched on again The lamp circuit failure,
before the lamp unit is abnormal function.
cooled enough.
Let the lamp unit cool
Contact an Authorised
down and turn on the
Service Centre.
MAIN POWER.
The room temperature is too
high.
Reinstall the projector in
temperature controlled place.
See page 48.
POWER LAMP TEMP
The lamp unit is
damaged.
See "Replacing the
lamp unit" on page 42.
The air filter is excessively dirty
and the ventilation is poor.
Replace the air filter in the
proper method. See page 41.