Installing the replacement drive
CAUTION:
Wait approximately 30 seconds
after removing the failed drive and before
installing the replacement drive. This timeframe
allows the enclosure to recognize that a drive
was removed from the enclosure and can then
recognize the replacement drive when it is
installed.
1.
On the replacement drive, prepare the drive by
pressing the drive ejector button and pivoting the
release lever to the full open position.
2.
Insert the replacement drive into the drive
enclosure, sliding the drive into the drive enclosure
as far as it will go. As the drive meets the
backplane, the release lever automatically begins
to rotate closed.
3.
Press firmly on the release lever to ensure that the
drive is fully seated.
4.
Wait approximately 30 seconds for the system to
discover the drive.
5.
Go to the SMU or CLI and confirm that the drive
is available for use.
Verifying proper operation
Confirm that the drive is operating normally. See
"Verifying drive status" (page
2).
Working with failed drives, spares, and
replacement drives
In MSA2000 and P2000 enclosures, when dynamic
sparing is enabled and a drive fails in a fault-tolerant
vdisk, if compatible drives are available, the storage
system automatically uses the drives to reconstruct the
vdisk. Vdisk reconstruction does not require I/O to be
stopped, so the vdisk can continue to be used while
the reconstruct utility runs. If dynamic sparing is not
enabled, you must manually set as a spare an
appropriately sized drive with the correct protocol so
that the rebuild can start.
When a failed drive is rebuilt on to a spare, the spare
becomes the new drive in the virtual disk and the
original drive slot position that failed is unused and is
no longer part of the virtual disk.
To make the replacement drive available for use as a
spare:
1.
In the SMU, make sure that the status of the drive
slot in which the replacement drive is installed is
Available. All new drives should be Available; if
the status is a different value, see the User Guide
or the Guided Troubleshooting for your MSA
model and determine what action to take.
2.
When the replacement drive is online and
Available, configure the drive to be a dedicated
spare or a global spare.
For information about vdisk reconstruction and using
the SMU, see the following resources for your MSA
product model:
Guided Troubleshooting
User Manual
SMU Reference Guide
CLI Reference Guide
Updating firmware
After installing any new component, verify that it is
running the latest firmware.
Go to the HP Support Center website and navigate to
the page for your MSA enclosure model. If newer
firmware is available, download the firmware from
the Web to your local system and install that latest
version on the drive. For more information on firmware
updates, see the SMU, CLI, or product user guide for
your MSA model.
Page 3