Advertisement
E T C S e t u p G u i d e
B u t to n C o n fi g u r a ti o n
Eos
Settings for the RVI can be altered in the Eos Configuration Utility (ECU). The 20 buttons on the front
panel of the RVI are configurable from the Buttons section of the ECU.
N o t e :
To configure the RVI buttons:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
•
•
Step 6:
Step 7:
To import a button configuration:
You may import an RVI button configuration file from a USB device.
Step 1:
Step 2:
Step 3:
To export a button configuration:
You may export your RVI button configuration to a USB device.
Step 1:
Step 2:
Step 3:
Step 4:
For more information on settings in the ECU, please see Appendix A: Eos Configuration Utility (ECU) in
the Eos or Ion Operations Manual.
Cob alt
Settings for the RVI buttons cannot be changed.
N et 3 R em o t e Vi de o I nt e rf a c e S et up G ui de
The buttons section of the ECU has two different areas, the RPU/ RVI face panel
buttons, and Gio face panel buttons. You will want to make sure you are in the
RPU face panel buttons area.
In the Eos browser, select File>Exit and confirm the selection. Eos will close and you will
enter the Eos welcome screen.
Click on the {Settings} button. This will open the ECU.
On the right side of the screen, click on {Buttons} to enter the RPU/RVI button setup. A
virtual display of the RPU/RVI buttons is displayed with the current button settings labeled
on each button.
Click on a button you wish to alter. A button popup window will open.
Click on the type of button you want it to be (Macro or Hard Key).
If Macro - Click on the Macro # box and enter the desired macro number from the key-
board and press enter. Then click {Accept}.
If Hard Key - Click on the {HardKey} drop down menu and select the hard key you
wish to use. Then click {Accept}.
Repeat this process for any other buttons you wish to reconfigure.
To restore the default buttons at any time, click the {Restore Defaults} button.
Click the {Import} button in the RPU/RVI area of the Buttons section of the ECU. The
ECU will search for a valid RVI button file.
If a valid file is found, the ECU will ask you if you want to import the settings. Click {Yes}.
The settings will be imported.
Click {Ok}.
Click the {Export} button in the RPU/RVI area of the Buttons section of the ECU.
If a USB drive is available, the ECU will ask you to choose the desired drive from the drop
down menu. Click on the desired USB drive.
Click {Accept}. The button configuration will be saved to the USB drive.
Click {Ok}.
Net3 Remote Video Interface
Page 4 of 4
El ec t r on ic T he at r e C on tr o ls , I nc .
Advertisement
