Panasonic DP-8060 Operating Instructions Manual page 170

No.
054 Fax Forward
056 Cover Sheet (HOME)
077 Department Code
078 Rotation XMT
082 Quick Memory XMT
086 Ringer Volume
089 List Output Tray
095 Duplex Print
097 Special Tray
NO.1 - 4
099 Memory Size
(Flash Memory)
118 FAX Function Detect
131 Job Tracking
170
Downloaded From ManualsPrinter.com Manuals
Setting Your Machine
Fax Parameter Table
Parameter Setting
Invalid
Valid
Off
On
Invalid
Valid
Invalid
Valid
Invalid
Valid
Off
Soft
Loud
Upper
Bottom
Invalid
Valid
None
Tray 1
Tray 2
Tray 3
Tray 4
LCT
-
Invalid
4-Digits
5-Digits
6-Digits
7-Digits
8-Digits
None
Tx
Rx
Tx & Rx
Selecting whether the machine performs Fax Forwarding to the specified
destination.
Setting the home position of the Cover Sheet parameter in the Select Mode.
(See page 96)
Selecting whether the machine performs the Department Code operation.
(See pages 112-117)
Selecting whether the machine performs rotation transmission.
Selecting whether the machine performs Quick Memory Transmission.
Invalid : Stores all documents into memory first before dialling the
telephone number.
Valid : Starts dialling the telephone number immediately after storing the
first page.
Setting the home position of the ringer volume when your machine
receives a call.
Selecting the Output Tray home position for List printout.
Upper : The List printout exits to the Upper Output Tray.
Bottom : The List printout exits to the Bottom Output Tray.
Selecting whether the machine performs duplex print when A4/Letter originals
are received.
Select up to 4 Special Trays that will not be used for printing received faxes
(4-Trays, plus LCT configuration). One Tray must always be available for
receiving Faxes.
(You can specify one Tray (1 ~ 4, LCT) for each selection No. 1, No. 2, No. 3
and/or No. 4)
Displays the amount of base and optional memory installed.
(Base Memory + Optional Memory)
Setting the number of digits for detecting a Fax Telephone number.
Upon detecting the specified number of digits, the machine will
automatically switch to the FAX Mode when it is in the Copier Mode. 4-Digits
None : Select Job Tracking function
Tx : Valid only in sending
Rx : Valid only in receiving
Tx & Rx : Valid both in sending and receiving
The Job Tracking is available under the following conditions. When "55 User
Authentication" in General Settings is set to "Fax(On)" or "Scanner(On)",
and "54 Fax Forward" in Fax Parameters is set to "Invalid".
Comments