Remote 2 In Terminal - Panasonic DLP PT-D6000 Functional Instructions

REMOTE 2 IN terminal

Using the REMOTE 2 IN terminal provided on the connection terminals of the main unit, it is possible to operate the
projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot be
received.
Projector set up in a meeting room
Pin assignments and control
NOTE:
• The following buttons on the remote control and the operation area of the projector can no longer be operated when pins
1 and 9 are shortened: POWER button and SHUTTER button. Neither will it be possible to use the RS-232C commands
or network functions corresponding to these functions.
• If you short pin 1 and pin 9, and also short one of the pins from 3 to 7 and pin 1, then the following buttons on the projector
operating area and the remote control can no longer be operated: POWER, RGB1, RGB2, DVI-D, VIDEO, S-VIDEO, SDI
and SHUTTER buttons. Neither will it be possible to use the RS-232C commands or network functions corresponding to
these functions.
Pin No. Signal name
GND
1
POWER
2
RGB1
3
4 RGB2
5 VIDEO
6 S-VIDEO
7 DVI-D
8 SHUTTER
9
RST / SET
Technical Information
Remote
terminal
Remote terminal/External control
Standby
LAMP
Control panel located in a different room
Open (H)
OFF
Other
Other
Other
Other
Other
OFF
Controlled by remote Controlled by external
control
External
control
ON
Short (L)
GND
ON
RGB1
RGB2
VIDEO
S-VIDEO
DVI-D
ON
contact
E
NGLISH - 47