Basic Format; Cable Specifications - Panasonic DLP PT-D6000 Functional Instructions

Technical Information

Basic format

STX A
(2 bytes)
Start
(1 byte)
NOTE:
• No command can be sent or received for 10 to 60 seconds after the lamp starts lighting. Try sending any command after
that period has elapsed.
• When transmitting multiple commands, be sure to wait until 0.5 seconds has elapsed after receiving the response from
the projector before sending the next command. When sending commands without parameters, a colon (:) is not
necessary.
• When the wrong command is sent, the "ER401" or "ER402" status is sent from the projector to the personal computer.
• Projector ID supported on the RS-232C interface is ZZ (ALL) and a group of 01 to 64 and 0A to 0Z.
• The "STX" character code is 02 and the "ETX" character code is 03.
• If a command is sent with a projector ID specified, the projector will return answer back only in the following cases:
If it coincides with the projector ID
If the ID specification is ALL and responding (ID ALL) is on
If the ID specification is Group and responding (ID Group) is on

Cable specifications

(When connected to a computer)
Control commands
Command Control contents
PON
POF
QPW
Switch input modes
IIS
Query for active lamp
QSL
Active lamp mode
LPM
Lamp power setting
OLP
E
NGLISH - 46
D I 1 I 2 ;
Semicolon
(1byte)
2 ID characters
(2 bytes)
ZZ, 01 to 64 and 0A to 0Z
ID designate
NC
NC
Projector
NC
NC
Power ON
In standby mode, all commands other than the PON command are ignored.
Power OFF
Power
000 = Standby
query
VID = VIDEO
RG1 = RGB1
DVI = DVI
0 = DUAL
2 = Only LAMP 1 is on
mode
0 = DUAL
2 = Only LAMP 1 is on
0 = HIGH
C1 C2 C3 :
Colon
(1byte)
3 command characters
(3 bytes)
NC
NC
NC
NC
Parameter/Remarks
The PON command is ignored during lamp ON control.
SINGLE will use the lamp (LAMP 1 or LAMP 2) with shorter operating hours.
P1 P2 - Pn ETX
Parameter
(undefined length)
End
(1 byte)
Computer
(DTE)
001 = Power ON
SVD = S-VIDEO
RG2 = RGB2
SDI = SDI (PT-DZ6710E only)
1 = SINGLE
3 = Only LAMP 2 is on
1 = SINGLE
3 = Only LAMP 2 is on
1 = LOW