Status; Filter Counter Reset; No Signal Shut-Off; Function Button - Panasonic DLP PT-D6000 Functional Instructions

PROJECTOR SETUP menu

STATUS

You can see the status of the projector about the following
items.
Items
INPUT
NAME
SIGNAL FREQUENCY
PROJECTOR RUNTIME
LAMP1
LAMP2
INTAKE AIR TEMP.
OPTICS MODULE TEMP.
AROUND LAMP TEMP.
REMAINING FILTER
QUANTITY
PROJECTOR TYPE
SERIAL NUMBER
MAIN VERSION
SUB VERSION
NETWORK VERSION
ON COUNT
POWER ON TIMES
LAMP1 ON
LAMP2 ON
SHUTTER
LAMP1 LOW
HIGH
LAMP2 LOW
HIGH
NUMBER OF ENTRY
SIGNAL
REMOTE2 STATUS
E
NGLISH - 30
Description
Displays the input selection state.
Displays the input signal name.
Displays the frequency of the input
signal.
Displays the projector runtime.
Displays the lighting time of LAMP1.
Displays the lighting time of LAMP2.
Displays the intake air temperature of
the projector.
Displays the temperature inside the
projector.
Displays the temperature around the
lamp of the projector.
Displays the filter runtime.
Displays the filter remaining quantity.
Displays type of projector.
Displays the serial number of the
projector.
Displays the main version of the
firmware of the projector unit.
Displays the sub version of the
firmware of the projector unit.
Displays the network version of the
projector unit.
Displays the number of times the
power has been tuned on.
Displays the number of times LAMP1
has been lit.
Displays the number of times LAMP2
has been lit.
Displays the number of times the
shutter function has been used.
Displays the LAMP1 lighting time with
LOW setting in LAMP POWER.
Displays the LAMP1 lighting time with
HIGH setting in LAMP POWER.
Displays the LAMP2 lighting time with
LOW setting in LAMP POWER.
Displays the LAMP2 lighting time with
HIGH setting in LAMP POWER.
Displays the number of registered
signals.
Displays REMOTE 2 IN control status.

FILTER COUNTER RESET

After you replaced the Auto Cleaning Filter (ACF),
REMAINING FILTER of STATUS need to be reset to "0".
1. Press the ENTER button.
2. Select OK by pressing I, then press the ENTER button.
3. The REMAINING FILTER of STATUS will be reset to
"0".
Display the STATUS and confirm the figure.
NOTE:
• See "Replacing the Auto Cleaning Filter (ACF)" in the
operating instructions booklet that is provided with the
projector.

NO SIGNAL SHUT-OFF

You can set the timer to switch off the power of the projector
after a certain period of time automatically when no signal is
detected. Press I H to select the required period from 10 to
90 minutes at intervals of 10 minutes.
DISABLE
FG
10 MIN.
FG
20 MIN.
FG
30 MIN.
FG
40 MIN.
FG
50 MIN.

FUNCTION BUTTON

You can assign a certain menu function to the FUNCTION
button as shortcut. Press I H to select the required menu
option, and the ENTER button.
Options
Deactivate the FUNCTION
DISABLE
button.
Displays the assigned SUB
SUB MEMORY LIST
MEMORY LIST.
Switches SYSTEM SELECTOR
SYSTEM SELECTOR
options.
SYSTEM DAYLIGHT Switches the SYSTEM
VIEW DAYLIGHT VIEW setting.
FREEZE Freezes the image.
SIDE BY SIDE Start the SIDE BY SIDE mode.
FG
90 MIN.
FG
80 MIN.
FG
70 MIN.
FG
60 MIN.
FG
Functions Refer
-
34
17
17
27
27