Setting Daylight Savings Time - Honeywell ADEMCO 6271 Series Installation And Setup Manual

•
When the time is set it will be stored in the TouchCenter and sent
to the control panel when you press the Apply button and answer
Yes to the following prompt. Additionally, when using the
TouchCenter with a residential panel, the panel will download its
time into the TouchCenter once an hour after the clock is set.
•
If Get Time is pressed, the TouchCenter will download the time
and date from the control panel and exit the Set Time & Date
screen. Note: This button appears with residential panels only.
•
If DST On (Daylight Savings Time) is selected, the TouchCenter
will adjust for Daylight Savings time at the month, week and
time chosen.

Setting Daylight Savings Time

Press the Time and Date button located at the bottom of the screen
and do the following:
SCREEN
SECTION 4: Initial Setup
ACTION
1. On the "Time and Date" screen, press
the Month/Day/Year "arrow" button in the
"Settings" area of the screen. A drop-
down list displaying the Month/Day/Year
display formats is displayed.
2. Select the display format you want by
pressing it. The drop-down list closes
automatically and the selection is
displayed.
3. Select if you want a 12-hour or 24-hour
format for your time display by touching
the circle to the left of the 12 Hour display
in the "Settings" area of the screen. A
check mark in the circle indicates a 12-
hour display format.
4. Select if you want Daylight Savings
Time to affect your system clock by
pressing the DST button in the "Settings"
area of the screen. The Daylight Savings
Screen will be displayed.
4–17