To Display And Select A Line; To Display Grid On The Graph - Agilent Technologies 4156b User Manual

Analyzing Measurement Results
Manual Analysis

To Display and Select a Line

1. Select LINE primary softkey.
2. Set LINE SELECT softkey to 1 or 2. Selecting this softkey toggles the setting.
3. Set LINE secondary softkey to ON. Selected line and two cursors are displayed.
Selecting the LINE secondary softkey toggles as follows:
OFF ® ON ® OFF
Set LINE SELECT secondary softkey to desired line (1 or 2). Selected line is
highlighted.
To select line to analyze
Selecting LINE SELECT secondary softkey toggles as follows:
1 ® 2 ® NONE ® 1
The following are independent for each line. So, changing the active line also
changes the following:
• locations of marker and cursors
• X and Y intercepts and gradient

To Display Grid on the Graph

1. Select DISPLAY SETUP primary softkey.
2. Set GRID secondary softkey to ON. Grid is displayed. Selecting GRID
secondary softkey toggles between ON and OFF.
To turn off grid
Set GRID secondary softkey to OFF.
5-18 Agilent 4155B/4156B User's Guide Vol.2, Edition 5