SeeMeCNC rostock max v2.0 Assembly Manual page 11

The white cardboard box will contain the laser cut Acrylic parts that are used in the build.
The Acrylic parts have a paper protective covering on them. Please leave that in place until
you're ready to install them.
The large cardboard box contains the hardware & electronic components required to build the
Rostock MAX v2. Many are in individual baggies, some are in heat-sealed bag "packs". As you go
through the following Bill of Materials, please count and check off each item. This is important as you
don't want to be short a vital part during the build. It's better to find out before hand than being forced
to stop the assembly process due to a missing part. If you are missing any parts, please contact
support@seemecnc.com
Rostock MAX v2 Assembly Guide – 4thEd.
Acrylic parts.
with the subject line of "Missing Parts!".
Hardware & Electronic Components
2 – Visual Bill of Materials – 11