Connect Sensor To Patient; Check The Recorder; Other Notes - EDAN M3 Service Manual

3.4 Connect Sensor to Patient

Connect all the necessary patient sensors between the monitor and the patient.
NOTE:
For information on correct connection, refer to related chapters in User manual.

3.5 Check the Recorder

If your monitor is equipped with a recorder, open the recorder door to check if paper is properly
installed in the slot. If no paper present, refer to User manual for details.

3.6 Other Notes

l When the monitor is used with other electrical medical equipment, it should comply with the
relative regulations to protect against burns to the patient and medical staff.
l EXPLOSION HAZARD-Do not use the device in a flammable atmosphere where
concentrations of flammable anesthetics or other materials may occur.
M3 Vital Signs Monitor Service Manual
- 25 -