Operation
•
•
A
Cutting to specified dimensions
The cutting size can now be set with the
•
handle
.
F
Insert paper and move by means of the
•
stacking angle to the backgauge
lay on the left
I
Move the pressing lever
•
slight swing (only IDEAL 4315).
Close the front safety guard
•
Release the cut.
•
Cut according to markings
Adjust the backgauge with the crank handle
•
to the back.
F
Insert paper and move by means of the
•
stacking angle to the backgauge
side
lay on the left
I
Turn crank handle
•
marking on the paper to be cut is below the
cutting line indicator.
Move the pressing lever
•
slight swing (only IDEAL 4315).
Close the safety guard
•
Release the cut.
•
Cutting activation
Warning!
The front safety guard must be opened
•
completely before every cut (A).
Run backgauge to the front for turning the
•
paper stack.
Do not interrupt the upward movement of the
•
blade by performing switching procedures.
Close the front safety guard
•
Blade must always be at the top and be
•
covered by the clamp. Do not touch the blade
- risk of injury! (see security information on
page 32).
- 23 -
and side
H
.
to the left by a
D
A.
H
.
to the right until the
F
to the left by a
D
A.
A.
and