Advertisement
Using Your Kambrook Blender
NOTE: Use ground ingredients
immediately or attach the
reusable lid to store in the
refrigerator for later use.
Overload Protection System
The motor is protected from burning
out by a manual reset cut-out switch.
If the blender is overloaded or
operated continuously for too long,
the motor may overheat and stop. To
operate the blender again, you must
switch off, unplug and allow to cool
for approximately 30 minutes. Once
the motor has fully cooled, it is ready
for use again. Some dense mixtures
may cause the blending blade to
rotate more slowly than normal. Do
not operate the blender continuously
with an excessive load for more than
30 seconds. If this occurs again, the
cup may be overloaded, so remove
some of the food and process in
smaller batches.
14
continued
Care, Cleaning and Storage
Cleaning After Use
1.
Switch off at the power outlet and
unplug the power cord.
2. Ensure the blender has
completely stopped operating
before removing the cup from the
motor base.
3.
Hold the motor base with hand
and with the other hand turn the
assembled cup anti-clockwise
in the direction of the 'OFF'
symbol on the motor base. Lift the
assembled cup from the motor
base to remove.
4. Flip the cup so that the blade
holder is at the top (See Fig. 14).
Fig. 14
5. Carefully unscrew and remove
the blending or grinding blade
holder from the cup.
6. Wash the blending blade holder
in warm soapy water and dry
thoroughly.
7.
Wipe out the grinding blade
with a slightly damp cloth and
dry thoroughly. To thoroughly
clean under the grinding blade,
align and lock the empty cup
to the motor base and operate
the empty cup for less than 30
seconds. This should dislodge any
particles under the blades. Switch
off and unplug before continuing
to clean.
WARNING: Blades must
be handled carefully as
they are sharp!
NOTE: Do not immerse the
grinding blade holder in water
or any other liquid.
8.
Ensure all liquids and foodstuffs
have been removed from the
cups. Wash the cups with warm
soapy water. Use a plastic
bottle brush to clean any tough
foodstuffs left inside the cups.
Wash the cups and reusable lids in
warm, soapy water. Rinse and dry
thoroughly.
9.
Ensure all liquids and foodstuffs
have removed from the sports
bottles. Use a plastic bottle brush
to clean any tough foodstuffs
left inside the bottles. Wash the
sports bottles and drinking lids in
warm, soapy water, rinse and dry
thoroughly.
NOTE: Do not place any part
of the blender, including the
blending cups and sports
bottles in the dishwasher.
Dishwashers vary in the market
and some dishwashers may
have hot spots that may distort
the plastic.
15
Advertisement
