Problems And Warning Signals - Janome Skyline S9 Instruction Book

Problems and Warning Signals

If the visual touch screen shows a warning sign, follow the guidance below.
Warning Sign Cause
The start/stop button is pressed with the foot control
connected.
The foot control is out of order.
The bobbin winder spindle is shifted to the right.
The machine will stop if the buttonhole is sewn without
lowering the buttonhole lever.
The twin needle key is pressed when the twin needle sign
is indicated on the LCD screen.
The machine is started without lowering the feed dog with
button sewing selected.
The machine is started with the feed dog lowered.
The needle plate is removed.
The machine is halting due to overload.
The machine is malfunctioning.
161
Try this
Disconnect the foot control.
Contact the service center
or the store from whom the
machine was purchased.
Shift the bobbin winder
spindle to the left for
stitching.
Lower the buttonhole lever
and start the machine again.
Replace the twin needle with
a single needle and press
the OK key.
Lower the feed dog.
Raise the feed dog unless
you want to sew with the
feed dog lowered.
Attach the needle plate.
Check if the needle plated is
attached properly.
Wait for at least 15 seconds
to restart. Remove tangled
threads around take-up lever,
hook race and automatic
thread cutting mechanism.
Contact the service center
or the store from whom the
machine was purchased.