Table of Contents
Advertisement
2-5. Driving information
● Disconnecting
Set the height control of electronically modulated air suspen-
sion system to N mode.
Set the electronically modulated air suspension system to
MAN. (manual).
Turn off the engine.
Set the supporting leg of the trailer on the ground and raise
the hitch by 4 in. (100 mm).
2
Turn the engine switch to the START position and start the
engine.
Press the height control mode select switch to cancel the
MAN. (manual) condition that was set on
. Check that
the MAN. indicator turns off.
Wait until vehicle height is stabilized.
Make sure the hitch is disconnected. If the hitch does not dis-
connect, raise the hitch higher and repeat steps 2 through 7.
Move the vehicle forward in LO mode where the hitch does
not touch anything in N mode.
Set the height control of electronically modulated air suspen-
sion system to N mode.
281
Advertisement
Table of Contents
