Toyota 2016 Sequoia Manual page 214

Hide thumbs Also See for 2016 Sequoia:
Table of Contents

Advertisement

2-4. Using other driving systems
Dynamic laser cruise control can be set when
The shift lever is in the D or range 4 or higher of S has been selected.
Vehicle speed is above approximately 30 mph (50 km/h).
Switching modes
The mode cannot be switched to constant speed control mode if vehicle-to-
vehicle distance control mode has been used. The mode also cannot be
switched from constant speed control to vehicle-to-vehicle distance control
mode. Turn the system off by pressing the ON-OFF button, and turn it on
again.
Accelerating after setting the vehicle speed
The vehicle can accelerate normally. After acceleration, the set speed
resumes. However, during vehicle-to-vehicle distance control mode, the
vehicle speed may decrease below the set speed in order to maintain the
distance to the vehicle ahead.
Automatic cancelation of vehicle-to-vehicle distance control
Vehicle-to-vehicle distance control driving is automatically canceled in the
following situations:
Actual vehicle speed falls below approximately 25 mph (40 km/h)
VSC is activated
The sensor cannot operate correctly because it is covered in some way.
The windshield wipers are operating at high or low speed.
The operation cannot be switched for 5 seconds or more after operating
the front wheel drive control switch or the center differential lock switch.
(4WD models)
*
:Vehicle-to-vehicle distance control driving must be reset by pressing the
ON-OFF button again.
If vehicle-to-vehicle distance control driving is automatically canceled for any
other reason, there may be a malfunction in the system. Contact your Toyota
dealer.
214
*
*

Advertisement

Table of Contents
loading

Table of Contents