Table of Contents
Advertisement
2-5. Driving information
■
Service connector for towing brake controller (with towing package)
Connecting
electronically modulated air suspension)
If a height control system is installed in your vehicle, you have to con-
nect and disconnect your trailer more carefully.
● Connecting
Set the height control of electronically modulated air suspen-
sion system to N mode.
Turn off the engine, or set the electronically modulated air
suspension system to MAN. (manual).
Connect the trailer.
Turn the engine switch to the START position and start the
engine.
Press the height control mode select switch to cancel the
MAN. (manual) condition that was set on
Check that the MAN. indicator turns off.
Set the height control of electronically modulated air suspen-
sion system to N mode.
280
Your vehicle is equipped with a service
connector for the trailer brake controller
as shown.
Access the service connector.
and
disconnecting
Remove the scuff plate.
Remove the clip (screw type) and trim
board.
a
trailer
(vehicles
with
.
Advertisement
Table of Contents
