Using The Rj-45 Connectors - HP E2620 Installation And Getting Started Manual

Installing the Switch
Installation Procedures
2-16

Using the RJ-45 Connectors

To connect:
Push the RJ-45 plug into the RJ-45
port until the tab on the plug clicks
into place. When power is on for the
switch and for the connected device,
the Link LED for the port should
light to confirm a powered-on device
(for example, an end node) is at the
other end of the cable.
If the Link LED does not go on when
the network cable is connected to
the port, see "Diagnosing With the
LEDs" in chapter 4,
"Troubleshooting".
To disconnect:
Press the small tab on the plug and
pull the plug out of the port.
Unshielded twisted-pair cable:
• Category 3, 4, or 5 for 10 Mbps ports
• Category 5 or better for 100 Mbps ports
• Category 5e or better for 1000 Mbps ports
Maximum distance: 100 meters
Figure 2-10. Connecting network cables
RJ-45 connector