Toyota 2007 4runner Owner's Manual page 456

06 06.07
CY19034
5. Test the operation of the HomeLink
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate,
identify if your garage transmitter is of the
"Rolling Code" type. Press and hold the
R
programmed HomeLink button.
garage door has the rolling code feature if
the indicator light (on the HomeLink
flashes rapidly and then remains lit after 2
seconds. If your garage transmitter is the
"Rolling Code" type, proceed
heading "Programming a rolling
system".
310
6. Repeat steps 2 through 5 for each re-
R
maining HomeLink
another device.
Programming a rolling code system
If your device is
equipped, it is necessary
steps 1 through 4 under the heading
"Programming the HomeLink
proceeding with the steps listed below.
1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
R
door opener. Refer
by
guide supplied by the garage door
opener manufacturer for the location of
this "training" button.
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
The
3. Press and release the vehicle's pro-
R
grammed HomeLink
R
)
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
to the
press and release the button a third
code
time. This third press and release will
complete the programming process by
opening the garage door.
The ceiling mounted garage door opener
button to program motor should
R
HomeLink
garage door up/down.
4. Repeat steps 1 through 3 for each re-
"Rolling Code"
maining HomeLink
to follow
another rolling code system.
R
" before
Programming an entrance gate/program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
tons you want to program.
2. Place your
transmitter 25 to 75 mm (1 to 3 in.)
to the owner's
away from
HomeLink
Keep the indicator light on the HomeLink
in view while programming.
3. Press
HomeLink
4. Continuously press and release (cycle)
the hand−held gate/device transmitter
button every two seconds until step 5
button twice. The
is complete.
5. When the
HomeLink
rapid flash after 20 seconds, you can
release both buttons.
2007 4Runner from Aug. '06 Prod. (OM35866U)
now recognize the
unit and be able activate the
R
button to program
R
but-
hand−held gate/device
the surface of the
R
.
R
and hold the selected
R
button.
indicator light on the
R
changes from a slow to a