Toyota 2007 4runner Owner's Manual page 305

06 06.07
CY16072
Type A
CY16071
Type B
IF THE TIRE PRESSURE WARNING
LIGHT BLINKS...
If the tire pressure warning light blinks
when the ignition key is turned to the
"ON" position, the tire pressure warn-
ing system is not working properly.
The system will be disabled in the follow-
ing conditions:
(When the condition becomes normal, the
system will work properly.)
D
If tires not equipped with tire pressure
warning valves and transmitters are
used.
D
If the ID code on the tire pressure
warning valves and transmitters is not
registered.
D
If electronic devices or facilities using
similar radio wave frequencies
nearby.
D
If a radio set at similar frequencies is
in use in the vehicle.
D
If a window tint that affects the radio
wave signals is installed.
D
If there is a lot of snow or ice on the
vehicle, in particular around the wheels
or wheel housings.
D
If non−genuine Toyota wheels are used.
2007 4Runner from Aug. '06 Prod. (OM35866U)
D
If tire chains are used.
D
If the spare tire is in a location subject
to poor radio wave signal reception.
D
If the tire inflation pressure is more
2
than 500 kPa (5 kgf/cm
or higher than the specified level.
If the tire pressure warning light continues
to blink when the ignition key is turned to
the "ON" position, have
checked by your Toyota dealer.
Even if you use genuine wheels, the tire
pressure warning system may not work
properly with some types of tires.
are
or bar, 70 psi)
the system
193