Ignition Switch - Toyota 2007 4runner Owner's Manual

06 06.07

Ignition switch

CY16026
"START"—Starter motor on. The key
will return to the "ON" position when
released.
For starting tips, see page 355 in Section
3.
"ON"—Engine on and all accessories
on.
This is the normal driving position.
"ACC"—Accessories such as the radio
operate, but the engine is off.
If you leave the key in the "ACC" or
"LOCK" position and open the driver's
door, a buzzer will remind you to remove
the key.
158
"LOCK"—Engine is off and the steering
wheel is locked. The key can be re-
moved only at this position.
You must push in the key to turn it from
"ACC" to the "LOCK" position. The selec-
tor lever must be in the "P" position be-
fore pushing the key.
Once you remove the key, the engine im-
mobilizer system is automatically set. (See
"Engine immobilizer system" on page 14
in Section 1−2.)
When starting the engine, the key may
seem stuck at the "LOCK" position. To
free it, first be sure the key is pushed all
the way in, and then rock the steering
wheel slightly while turning the key gently.
Approximately five hours after the engine
is turned off, you may hear sound coming
from underneath the luggage compartment
for several minutes. This is normal opera-
tion and does not indicate a malfunction.
(See "Leak detection pump" on page x.)
It is not a malfunction if the needles on
all meters and gauges move slightly when
the key is turned to the "ACC", "ON" or
"START" position.
2007 4Runner from Aug. '06 Prod. (OM35866U)
NOTICE
Do not leave the key in the "ON"
position if the engine is not running.
The battery will discharge and the
ignition could be damaged.