Clutch Lever - Yamaha 2011 V Star XVS650AA Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
4
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch " "
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
Hazard switch " " (XVS650AA)
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
EAU12500
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU12660
/ "
gine not running, otherwise the bat-
" before starting
tery may discharge.
" to
EAU12711
EAU12733
" posi-

Clutch lever

ECA10061
1. Clutch lever
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handle-
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
4-18.)
4-7
EAU12820