Daytime Running Lights - If Equipped - Jeep 2013 Grand Cherokee SRT8 Owner's Manual

To Activate
1. Enable the Automatic High Beams. Refer to "Elec-
tronic Vehicle Information Center (EVIC)/Customer-
Programmable Features" in "Understanding Your In-
strument Panel" for further information.
2. Turn the headlight switch to the AUTO headlight
position.
3. Push the multifunction lever away from you (toward
front of vehicle) to engage the high beam mode.
NOTE: This system will not activate until the vehicle is
at or above 20 mph (32 km/h).
To Deactivate
1. Pull the multifunction lever toward you (or rearward
in car) to manually deactivate the system (normal
operation of low beams).
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 197
2. Push back on the multifunction lever once again to
reactivate the system.
Daytime Running Lights — If Equipped
The Daytime Running Lights (low intensity) come on
whenever the engine is running, and the transmission is
not in the PARK position. The lights will remain on until
the ignition is switched to the OFF or ACC position or the
parking brake is engaged. The headlight switch must be
used for normal nighttime driving.
NOTE: The Daytime Running Lights will not turn off
automatically when a turn signal is in operation and turn
on again when the turn signal is not operating.
3