Prepare The Icm - KVH Industries tracphone v3ip Installation Manual

4

Prepare the ICM

Follow these steps to prepare the ICM for
installation.
Connect the ICM Jumper Cables
Connect the three supplied jumper cables to the
rear panel of the ICM (see Figure 6).
a. Connect the serial data cable from the "A1"
jack to the "A2" jack.
b. Connect the straight-through Ethernet cable
from the "B1" jack to the "B2" jack.
c. Connect the BUC power cable from the "C1"
jack to the "C2" jack.
Attach the Wi-Fi Antennas
Connect the two supplied Wi-Fi antennas to the
rear panel of the ICM (see Figure 6).
Figure 6: Jumper Cables Wiring and Wi-Fi Antennas
ICM
C2
A2
Wi-Fi Antenna (x2)
B1
B2 A1
C1
7