KVH Industries tracphone v3ip Installation Manual page 18

11 Continued
Connect the RF Cables
IMPORTANT!
If you are using LMR-600-75 cables, do not
connect them directly to the ICM. Connect the
supplied 1 ft (30 cm) pigtail cables between
the RF cables and the ICM. Be sure to use the
white pigtail cable (labeled "TX ONLY") at
the ICM's "TxRF" jack.
a. Connect the RF coax cable labeled "RX" to the
"Rx RF" jack on the back of the ICM (see
Figure 25). Hand-tighten, then tighten with a
7/16" torque wrench set to 20 in.-lbs.
b. Connect the RF coax cable labeled "TX" to the
"Tx RF" jack on the back of the ICM. Hand-
tighten, then tighten with a 7/16" torque
wrench set to 20 in.-lbs.
IMPORTANT!
Be sure the RF cables are terminated properly
with type "F" connectors.
Wire the ICM
Figure 25: Antenna RF Transmit and Receive Wiring
MTx
ICM
RxRF TxRF
Antenna
MRx
Pigtails
Rx Pigtail
(Black)
Pigtails
(if necessary)
RxRF TxRF
Tx Pigtail
(White)
17