Wire The Icm - KVH Industries tracphone v3ip Installation Manual

11

Wire the ICM

Follow these steps to wire the ICM (see page 44
for a complete wiring diagram).
Connect the Antenna Power/Data Cable
a. First dress the power/data cable from the
antenna. Strip back the insulation of each
wire approximately 1/4" (6 mm) and gently
twist each wire to ensure a good electrical
connection.
b. Connect the antenna power/data cable to the
supplied 16-position terminal strip connector
as shown in Figure 21.
IMPORTANT!
The diagram refers to wires by body color/
stripe color. For example, "Brown/White"
means the brown wire with white stripe.
c. Place the terminal strip connector into the
base of the supplied cable shroud as shown in
Figure 22.
d. Secure the end of the power/data cable to the
base of the shroud using the supplied clamp.
This clamp will help relieve stress on the
cable. Secure the clamp in place with the two
screws.
e. Carefully fit all of the power/data cable's
wires within the base of the shroud.
f. Snap the shroud's cover onto the base. Be
sure not to pinch any wires between the cover
and the base.
g. Plug the terminal strip connector into the rear
panel of the ICM.
Figure 21: Antenna Power/Data Wiring
ICM
Terminal Strip Connector
1 2 3 4
Power
Red
Black
Data
White/Gray
Gray/White
White/Orange
Orange/White
White/Brown
Brown/White
White/Blue
Blue/White
Six unused wires are reserved for future use;
N/C = Not Connected
Figure 22: Power/Data Cable Shroud
Antenna
5 6 7 8 9 10 11 12 13 14 15 16
N/C
Cover
Terminal Strip Connector
Base
Clamp
Power/Data Cable
15