Other Problems - Miele PT 5135 C OS Operating And Installation Instructions

Other problems

Problem
The drying
process goes on
too long or even
switches off.
Possible cause
You might be asked to
clean the ducting
system/filters again.
Ventilation to and from the
dryer may be insufficient,
e.g. because it is installed
in a room which is too
small. This can cause the
temperature in the room to
rise sharply.
The vents below the door
are blocked.
The fluff filters are
clogged up with fluff or
were still wet when they
were replaced.
Detergent residues, hair
and fine fibres can block
the condenser unit.
The laundry has not been
spun sufficiently.
The tumble dryer has
been overloaded.
Metallic components, e.g.
zips have prevented the
dryer from registering the
correct moisture level in
the laundry.
Problem solving guide
Remedy
Please check all possible
causes, described below.
Open a door or window while
the dryer is in operation for
increased air flow.
– Remove any objects that are
blocking the vents.
– Remove any fluff.
– The fluff filters must be
completely dry.
Check the condenser unit from
time to time and clean it if
necessary.
Make sure that your laundry is
thoroughly spun at the
appropriate spin speed in the
washing machine.
Do not exceed the maximum
load for the programme
selected.
– Open zips next time.
If the problem occurs again,
dry garments with long zips
using the Warm air programme
(timed drying).
43