Replacing The Condenser Unit - Miele PT 5135 C OS Operating And Installation Instructions

^ Check the condenser unit again for
any visible fluff, and if necessary
flush it through again until it has all
gone.
^ Also make sure the rubber seals are
clean.
The rubber seals must not be
removed and must be free of kinks.
To check and clean the condenser unit
housing
^ Remove any soiling still visible inside
the housing by hand using a damp
cloth. Do not try and access areas
you cannot reach by hand.
Cleaning and care

Replacing the condenser unit

^ Push the condenser unit all the way
back into the housing, until it clicks
into place.
The handle for the condenser unit
must be at the top, and the lever at
the bottom.
^ Turn the lever down to the horizontal
position, making sure that the hook
on the lever clicks into the groove at
the bottom.
When replacing the inner cover,
ensure that the rubber seal fits
correctly into the groove.
^ Replace the cover making sure the
hooks locate correctly. To do this,
hold it at an angle and push it gently
downwards.
^ Then turn the lever upwards into the
horizontal position to lock the cover.
^ Replace the service panel and press
the upper edge until it clicks into
position.
It is important to ensure that both the
condenser unit and the cover are
correctly positioned and locked
otherwise water may leak from the
machine.
39