Table of Contents
Advertisement
Other problems
Problem
There are humming
noises
A programme does not
start
After the DryCare 40
Extra is selected, the
drying level "jumps"
back to a different level.
Only the Start/Add
laundry sensor control
flashes slowly when the
programme is running.
The tumble dryer is
switched off.
Cause and remedy
The compressor is operating.
These noises are quite normal and do not indicate a
fault.
No obvious cause.
Connect the tumble dryer to the mains
Turn on the tumble dryer
Close the door
Check whether the mains fuse has tripped
Has there been a power cut? When power is re-
stored any previously running programme will re-
start automatically.
The drying level selected previously cannot be com-
bined with the Extra. The next possible drying level
is selected automatically.
Once the programme has been running for
10 minutes, the indicators go out. The Start/Add
laundry sensor control flashes slowly. This is not a
fault, but a normal function to help save energy.
Touch a sensor control to switch on the indicators.
See " Control field standby status" in "Program-
mable functions".
The tumble dryer switches off automatically after
15 minutes if no further selections are made. This is
not a fault, but a normal function.
Select a programme.
Problem solving guide
59
Advertisement
Table of Contents
