Audiovox AV-970 Owner's Manual And Installation Manual page 9

FORD-LINCOLN-MERCURY INSTALLATION -1985 AND NEWER
ImRortant- This installation is designed for most 1985 through 1990 U.S. made Ford cars, and vans and an
installation kit is required forthese vehicles. See Kit Listing on Page 2 of this manual or refer to the in-store application
chart. For 1991 and newer vehicles, the radio can be installed as shown on Page 3 of this manual or you can use
theAX-88-SNP kit. Instructions for use oftheAS-88-SNP kit are included with the kit and are not shown inthis manual.
1. Remove Existing Radio:
A. Remove existing dashboard trim panel surrounding the radio opening. This panel is usually secured by screws
and/or snap-in clips.
B. Remove the screws used to secure radio to the sub-dashboard.
C. Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-plug the wiring harness(es) and antenna cable and remove the radio.
2. Install the le. Radio:
A. Follow the instructions included with the installation kit to attach the radio to the mounting plate supplied with
the kit.
B. Place the radio near the dashboard so the wire can be led through the opening and following the instructions
of Step 2 on Page 7, carefully wire the radio making certain all connections are secure and insulated and
confirm proper operation.
C. Install the radio/mounting plate assembly to the sub-dashboard according to instructions of installation kit.
D. Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut
provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above orbelow
the radio using the screw and nut provided. Bend the strap to position it as necessary.
CAUTION: The rear of the radio mY..$.l be supported with the strap to prevent damage to the dashboard from the
weight of the radio or improper operation of the radio due to vibration.
E. Replace the dashboard trimpanel.
F. Install knobs on radio shafts.