Cleaning The Inlet Hose Filter - Miele PW 6080 Vario Operating And Installation Instructions

Cleaning the inlet hose filter

The washer has two water inlet filters to
protect each inlet valve. Check and
clean these filters every 6 months. This
may have to be done more frequently
with some water supplies.
Cleaning the inlet hose filters
^ Turn off the water supply.
^ Unscrew the inlet hose from the valve
by turning the connector
counterclockwise using a wrench if
necessary.
^ Remove the rubber seal, 1, from the
connector.
^ Using needle nose pliers, grasp the
plastic filter, 2, and pull it out of the
hose connector.
^ Clean the filter under running water
and carefully remove any large
particles.
^ Replace the filter and seal and
reconnect the hose.
Cleaning and care
Slowly turn on the water supply and
check for leaks. If water leaks,
tighten the hose connection.
To clean the filter in the water inlet
valve:
^ Using pliers, carefully loosen the
ribbed plastic nut on the inlet valve
and unscrew.
^ Using needle nose pliers, remove the
plastic filter by pulling on the bar (see
illustration). Rinse under running
water and return. Replace the filter
and seal, then reconnect the hose.
Both filters must be put back in
place after cleaning.
37