Installing The Network Connector; Removing The Coin-Cell Battery - Dell Latitude E6540 Owner's Manual

Installing the Network Connector

1. Align the network connector to its position on the computer.
2. Place the network-connector bracket on the network connector.
3. Tighten the screw to secure the network-connector bracket to the computer.
4. Route the cable through the routing channel.
5. Connect the cable to the system board.
6. Install:
a. base-corner cover
b. base cover
c. battery
7. Follow the procedures in

Removing the Coin-Cell Battery

1. Follow the procedures in
2. Remove:
a. battery
b. base cover
3. Disconnect the coin-cell battery cable, pry the coin-cell battery upward, and remove the coin-cell from the
computer.
(left)
After Working Inside Your
Before Working Inside your
Computer.
computer.
21