2-Wire Settings In Azedit - RTS Zeus III User Manual

22 Introduction

2-Wire Settings in AZedit

The 2-Wire Setting window, shown in Figure 11, is used to override the DIP switch settings you set on the Zues III unit (see
"Dip Switches" on page 18) using AZedit.
NOTE: CH-A or CH-B must be selected for the 2-Wire Settings page to be available.
NAVIGATION: On the Keypanel / Ports Window, select the Edit button (see Figure 12).
2-Wire Settings Page
FIGURE 11.
2-Wire Settings Group Box
Use the 2-Wire Settings options to either use the currently set DIP switches, as set in the Zeus III or to override the DIP
switch settings for the selected channel. You can set CH-A and CH-B independent from each other, if desired.
Use DIP Switch Settings Radio Button
The Use DIP Switch Settings radio button indicates the currently set DIP switch settings should be used. The current settings
are displayed below the radio button.
Manually Override Settings Radio Button
The Manually Override Settings radio button allows the user to select override options to the currently set DIP switch
options. Once the Manually Override Settings radio button is selected, the override options check boxes become active below
the radio button.
Available override check box options are:
Half Duplex Check Box - Half Duplex operation is enabled.
Full Duplex Check Box - Full Duplex operation is enabled. Audio flows in both directions simultaneously.
Disable Noise Suppression Check Box - Noise suppression is disabled.
Enable Noise Suppression Check Box - Noise suppression is enabled.
Bosch Security Systems, Inc.
Technical Manual
Zeus III
F.01U.193.289 Rev. 05