Move The Front Connector Into Wiring Position - Siemens S7-300 Installation Manual

:LULQJ
Figure 7-4 Move the front connector into wiring position
Table 7-7

Power supply switched off (PS)

Opened module

Front connector in wiring position
:LULQJ WKH IURQW FRQQHFWRU
Table 7-8 Wiring the front connector
6WHS
(1) Thread the cable strain relief into the front
connector.
(2) Do you want to exit the cables at the bottom of the module?
,I \HV
Starting at terminal 20, work your way down
to terminal 1.
,I QRW
Starting at terminal 1, work your way up to
terminal 20.
7-10
2
P S
C P U
2
3
1 1
Assignment of front connectors to modules
7KH GLDJUDP LOOXVWUDWHV XQGHU QXPEHU
SLQ IURQW FRQQHFWRU
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
SLQ IURQW FRQQHFWRU
–
Starting at terminal 40 or 20, wire the
connector, working in alternating passes
from terminals 39, 19, 38, 18 etc. until you
have reached terminals 21 and 1.
Starting at terminal 1 or 21, wire the
connector, working in alternating passes
from terminals 2, 22, 3, 23 etc. until you
have reached terminals 20 and 40.
A5E00203919-01