&RPPLVVLRQLQJ
3* IRU FRPPLVVLRQLQJ RU PDLQWHQDQFH
1. For commissioning or service, connect the programming device (PG) to a
subnet node by means of a stub cable. The bus connector of this node must be
equipped with a PG socket.
2. You must energize the terminating resistor for the bus cable connectors going
into the CPU.
3. You use a PROFIBUS bus cable to network the CPUs.
Figure 9-5 Connecting a PG to a subnet
Stub cable used to create connection between PG and CPU
Energized terminating resistor of the bus cable connector
PROFIBUS bus cable used to network both CPUs
9-10
PG
1
3
7KH GLDJUDP LOOXVWUDWHV XQGHU QXPEHU
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
PS
CPU
2
SF
S F
SIEMENS
S IE ME N S
BUSF
BUS F
DC5V
DC5V
FRCE
FR CE
RUN
R UN
S T OP
STOP
PS
CPU
2
SM
SM
A5E00203919-01