Editing Data For Each Channel (Channel) - Yamaha PSR-S770 Reference Manual

Editing Data for Each Channel (CHANNEL)

You can edit recorded data for each channel of the current Section selected on the BASIC page or via the
panel buttons. The instructions below apply to step 5 of the Basic Procedure on
2
1
In the CHANNEL page, use the [A]/[B] buttons to select the edit menu.
1 QUANTIZE
Same as in the Song Creator
below.
2 VELOCITY CHANGE
Boosts or cuts the velocity of all notes in the specified channel, according to the percentage specified here.
3 BAR COPY
This function allows data to be copied from one measure or group of measures to another location within
the specified channel.
[4 ]
[5 ]
[6 ]
4 BAR CLEAR
This function clears all data from the specified range of measures within the selected channel.
5 REMOVE EVENT
This function lets you remove specific events from the selected channel.
2
Use the [1 ]/[2 ] (CHANNEL) buttons to select the channel to be edited.
The selected channel is shown at the upper left of the display.
3
Use the [4 ]–[8 ] buttons to edit the data.
4
Press the [D] (EXECUTE) button to actually enter the edits for each display.
After the operation is completed, this button changes to "UNDO," letting you restore the original data if
you are not satisfied with the results of the edit. The Undo function only has one level; only the previous
operation can be undone.
NOTICE
The edited Style will be lost if you change to another Style or turn off the power to the instrument without carrying out the Save operation
(step 7 on
40
PSR-S970/S770 Reference Manual
1
4
2
(page
TOP Specifies the first (TOP) and last (LAST) measures in the region to be
copied.
LAST
DEST Specifies the first measure of the destination location, to which the data is
to be copied.
page 31).
70), with the exception of the two additional available parameters
Eighth notes with swing
Sixteenth notes with swing
page 31.
5
3