Connecting With An Iphone/Ipad Via Wireless Lan; Infrastructure Mode - Yamaha PSR-S770 Reference Manual

Connecting with an iPhone/iPad via Wireless LAN

By using a USB wireless LAN adaptor (sold separately), you can connect the PSR-S970/S770 with an
iPhone/iPad via a wireless network. For general operating instructions, refer to the "iPhone/iPad Connection
Manual" on the website. This section covers only operations that are specific to the PSR-S970/S770.
Before starting operations, make sure that the USB wireless LAN adaptor is connected to the [USB TO
DEVICE] terminal and call up the setup display via [FUNCTION]
LAN.
If the USB wireless LAN adaptor is not recognized by the instrument, "WIRELESS LAN" for the [H] button is not shown. When "WIRELESS LAN" is not
NOTE
shown even though a USB wireless LAN adaptor has been connected, turn the instrument off then on again.

Infrastructure Mode

[A]/[B]
[G]
[I]
10
[1 ]/
[2 ]
[3 ]/
[4 ]
[5 ]/
[6 ]
[7 ]/
[8 ]
124
PSR-S970/S770 Reference Manual
Selects the network.
UPDATE Updates the network list on the display.
DETAIL For setting the detailed parameters on the pages below. After making these
settings, press one of the [7 ]/[8 ] (SAVE) button to actually save
them.
IP ADDRESS: Sets the IP address and other related parameters.
OTHERS: When the instrument is connected to the network with the
Infrastructure Mode, the current time is shown on the Main display.
You can set the Time Zone via the [B] button and Daylight Saving
Time via the [C] button for your local time.
If you want to enter the host name, press the [A] button.
WPS Connects this instrument to the network via WPS. Press this button fol-
lowed by the [G] (YES) button, then press the WPS button on your access
point within two minutes.
MODE Switches to the Access Point Mode.
INITIALIZE Initializes the connection setup to the default factory status.
CONNECT Connects to the selected network.
If you select "Other" by using the [A]/[B] buttons, this calls up the Man-
ual Setup display in which you set the SSID, security method, and pass-
word. After entering those, press one of the [7 ]/[8 ] buttons in
the Manual Setup display to connect to the network.
 TAB [F] MENU 2  [H] WIRELESS