Editing The Detail Tab Parameters - Yamaha PSR-S770 Reference Manual

 EFFECT parameters (selected by [E]/[J] buttons)
[4 ]/
TYPE
[5 ]
[6 ]
DEPTH
[7 ]
REVERB
[8 ]
CHORUS

Editing the DETAIL Tab Parameters

Use the [B]–[E] buttons to select the BAND PASS FILTER 1–5 or 6–10, then set the
value by using the [1 ]–[5 ] buttons.
NOTE Feedback (howling) may result depending on the setup settings. Be careful especially when you increase values.
 BAND PASS FILTER 1–10 parameters
Determines each output gain of the BPF 1–10 for the Inst Input (keyboard performance sound). The BPF 1
corresponds to the lowest Formant while the BPF 10 corresponds to the highest Formant.
Settings: -18dB – +18dB
Determines the specific type of effect applied to the lead Synth Vocoder
sound. A wide range of reverb, delay, modulation, distortion and other
special effects are available. You can edit the vocal effect by pressing
the [G] (VOCAL EFFECT EDIT) button (step 2 on
For a list of the effect types, refer to the Data List on the website.
Determines the amount of the effect (selected in TYPE above) applied
to the overall Synth Vocoder sound.
Determines the amount of reverb applied to the overall Synth Vocoder
sound.
Determines the amount of chorus effect applied to the overall Synth
Vocoder sound.
page 99).
PSR-S970/S770 Reference Manual
8
101