Connecting Voltage Measurement Cables - Dranetz PowerGuide 4400 User Manual

Connecting Voltage Measurement Cables

Connecting Voltage Measurement Cables
Measurement
cable set
Optional fused
voltage adapter
2-4
1.800.561.8187
Description: Voltage measurement cables are provided as standard accessories and are
stored in a cable pouch as part of the measurement cable set, P/N 116042-G3. Each
cable set consists of a cable and alligator clip.
Voltage Rating: Direct connection of all voltage measurement cables are rated at 600
Vrms max. For measuring voltages greater than 600 Vrms, potential transformers (PTs)
must be used.
Contents: The voltage measurement cables are shown on page 2-5 (positioned relative
to their actual use). A cable set consists of eight, 6-foot channel measurement cable
assemblies (probes), each with a detachable, alligator jaw, safety clip assembly
(maximum jaw opening, 3/4 in (20 mm)). The safety clip assemblies are red (+) and
black (-) for each of the four channels. One cable each of red (channel A), yellow
(channel B), blue (channel C), and grey (channel D), and four each of white are
provided.
A pouch for storage of the cables and the AC adapter/battery charger is included in the
contents of the measurement cable set, but is not shown in the figure.
There are two optional fuse accessory kits available for use with the measurement
cables. One kit (P/N FVA-1) contains one fused voltage adapter and one measurement
connecting Red cable 50 cm in length. The other kit (P/N FVA-4) contains four voltage
adapters and four measurement connecting cables 50 cm in length (one Red, one
Yellow, one Blue, and one Grey).
The single fuse voltage adapter kit is used for one single voltage measurement input.
While the four fuse voltage adapter kit is used for a three phase and neutral voltage
measurement inputs.
www.
information@itm.com
.com
Continued on next page