About The Controls; Cool Models; Heat Models; Vent Control - GE AJEM 10 Owner's Manual And Installation Instructions

About the controls on the air conditioner

Vent Control

The vent control is located behind the front grille on the right side of the
air discharge area. When CLOSED, only the air inside the room will be
circulated and conditioned. When OPEN, the vent allows outdoor fresh
air exchange.
To open or close the vent:
1. Remove the front grille.
2. Remove the vent card screw.
3. Remove vent card, turn it over and replace it by locating rear hole in
card over locating pin inside air discharge and reattaching screw at
front.
Air Direction
Cool Only Models
Auxiliary Controls – Dip Switches (location varies by model)
The auxiliary dip switch controls are located behind the
The owner is responsible for checking switches and
ensuring they are in the desired position.
Fan Cycle/Continuous - Cool
When this switch is enabled (RIGHT), it allows the indoor
fan to cycle on/off with the compressor. When this
switch is disabled (LEFT), it allows the indoor fan to run
continuously. The default setting is right (fan cycle).
Filter Reminder Funtion
When this switch is enabled (RIGHT), an LED will light
up the user interface after 250 of accumulated fan run
time. It serves as a reminder to clean the filter. When
this switch is disabled (LEFT), the function is disabled.
The default setting is right (enabled).
Heat/Cool Models
Auxiliary Controls – Dip Switches (location varies by model)
The auxiliary dip switch controls are located behind the
The owner is responsible for checking switches and
ensuring they are in the desired position.
8
Horizontal louvers
on the front grille let you
control the air direction up and
down.
The unit leaves the factory set at the CLOSE position.
Locating hole
Screw hole
OPEN position
(Mesh end toward back)
Remove the front grille
to adjust the vertical
louvers side-to-side
to direct the air left
or right.
COOL
FAN
HIGH
MODE
ON MED
OFF
TIMER TEMP
ON
- +
ON OFF SLEEP
OFF
Fan Cycle/Continuous - Cool
Filter Reminder Function
Fan Cycle/Continuous - Cool
Locating hole
Screw hole
CLOSE position
(Mesh end toward front)
Fan Cycle/Continuous - Cool
Filter Reminder
Function
Fan Cycle/
Continuous - Heat
Class 2
No function (reserved
for future use)