GE AJEM 10 Owner's Manual And Installation Instructions page 4

Appearance may vary.
Delay Hrs
On
Lights beside the touch pads on the air conditioner
Controls
1. Power On/Off
Turns air conditioner on and off.
2. Display
Displays the temperature setting. Displays hours when
setting the timer.
3. Mode
On the remote control, use to set the air conditioner to
Cool or Fan mode.
On the air conditioner controls, use to set Cool or Fan
mode at High, Med or Low fan speed. Indicator lights on
the air conditioner controls will show the mode and fan
speed selected.
4. Temp Increase + /Decrease – Pads
Use to set temperature when in COOL mode.
5. Fan Speeds
Use to set the fan speed at Low, Med or High.
6. Delay Hrs
When the air conditioner is off, it can be set to
automatically turn on in half an hour to 24 hours at its
previous setting. Each touch will set the time in half hours
up to 10 and then in hours up to 24.
Remote Control
To ensure proper operation, aim the remote control at the
signal receiver on the air conditioner.
The remote control signal has a range of up to 21 feet.
4
On
Off
Temp
Reset
Off
Filter
Air Conditioner Controls
control panel indicate the selected settings.
Cool
Fan
Hi
Mode
Med
Low
Power
On/Off
To cancel the Delay Timer, press the On pad until "CL"
appears. Then wait until the display turns off.
When the air conditioner is on, it can be set to
automatically turn off in half an hour to 24 hours. Each
touch will set the time in half hours up to 10 and then in
hours up to 24.
To cancel the Delay Timer, press the Off pad until "CL"
appears and wait for the set temperature to be displayed.
The unit will now resume normal operation.
7. Reset Filter
LED will turn on when fan has accumulated 250 hours of
run time as a reminder to clean filter. Press Reset Filter to
turn off the LED and reset the accumulated run time.
8. Remote Control Signal Receiver
NOTE: When the air conditioner is turned on, it will
automatically start in the setting last used
Make sure nothing is between the air conditioner and the
remote control that could block the signal.
the Care and Cleaning section.
Power
Cool Fan
Mode
Temp
High
Med
On
Delay
Hrs Low
Off
Remote Control
.